Right Rail Internal Repairs; Removing The Inner Rail Assembly; Figure 5-28 Right Upright Disassembly - GE Giraffe OmniBed Service Manual

Chapter 5: Repair Procedures

5.4.3 Right Rail Internal Repairs

5.4.3.1 Removing the Inner Rail Assembly

Refer to "Figure 5-26 Removing the Lift Motor", "Figure 5-28 Right Upright Disassembly", and "Figure 5-44
Heater Door Cable Adjustment".
Side roller bracket
1. Using a 2.5 mm hex key, remove the 2 screws located at either end of the upright in the rear dovetails
that secure belt channel to the inside of the upright. Using a 3mm hex key, remove the side roller bracket.
Remove the lift motor coupler components if still attached to the rail assembly. Pull the entire rail assembly
up out of the upright.
2. Remove the pinch guard by sliding it up then pulling it off.
96
Access hole

Figure 5-28 Right Upright Disassembly

6600-0343-000 104
Lift rail
Pinch guard
Buoyancy springs
Rollers
Belt block
Right upright
© 2001 by Datex-Ohmeda, Inc.. All rights reserved.
Belt channel
Motor bracket