Controller And Display Module Procedures; Display Module; Figure 5-57 Display Module - GE Giraffe OmniBed Service Manual

17. Dress the wire harnesses and install a cable tie.
18. Slide the reservoir seal into place.
19. When installing the humidifier assembly, rotate the cylinder so the max line is visible.

5.13 Controller and Display Module Procedures

5.13.1 Display Module

Refer to "Figure 5-57 Display Module".
Back cover
LED board
Display cage
1. Remove the 4 screws that hold the back cover on the display module and remove the cover.
2. To remove the display driver board, first remove the 4 screws the hold the board to the standoffs, then
disconnect the electrical connectors.
3. To replace the rotary encoder for the EL display, pull the control knob off the shaft, disconnect the electrical
connector, remove the nut that secures the encoder, and remove the encoder.
© 2001 by Datex-Ohmeda, Inc.. All rights reserved.
Display driver board
EL display
Display bezel

Figure 5-57 Display Module

Chapter 5: Repair Procedures
Rotary encoder
Membrane switch panel
Control knob
6600-0343-000 104
137