Indication Lamps - Mitsubishi MOTORS PAJERO OBKE10E1 Owner's Manual

Instruments and controls

Indication lamps

Turn-signal indication lamps/
Hazard warning indication
lamps
These indication lamps blink on and off
when a turn-signal lamp is operating.
NOTE
l If the blinking is too fast, a lamp
bulb may be blown or a turn-sig-
nal connection may be faulty.
3
When the hazard warning lamp switch is
pressed, all turn-signal lamps will flash
on and off continuously.
High-beam indication lamp
This indication lamp illuminates when
the high-beam is used.
Front fog lamp indication
lamp*
This indication lamp illuminates while
the front fog lamps are on.
Rear fog lamp indication lamp
This indication lamp illuminates while
the rear fog lamp is on.
3-08
Position lamp indication lamp
E00501600012
This lamp illuminates with the lamp
switch at " " or "
Diesel preheat indication lamp
E00501700068
(diesel-powered vehicles)
This indication lamp illuminates when
the ignition switch is placed in the "ON"
position. As the glow plug becomes hot,
the lamp goes out and the engine can be
started.
CAUTION
l If the diesel preheat indication
lamp blinks after the engine is
started, the engine speed may
not rise above the idling speed
E00501800072 because of fuel freezing. In this
case, keep the engine idling for
about ten minutes, then turn
off the ignition switch and im-
mediately turn it on again to
confirm that the diesel preheat
indication lamp is off.
E00501900132
NOTE
l If the engine is cold, the diesel pre-
heat indication lamp is on for a lon-
E00502000084
ger time.
l When the engine has not been star-
ted within about 5 seconds after
E00508900102
the diesel preheat indication lamp
went out, return the ignition
" position
switch to the "LOCK" position.
Then, turn the switch to the "ON"
position to preheat the engine
again.
E00502300146 l When the engine is warm, the die-
sel preheat indication lamp does
not come on even if the ignition
switch is placed in the "ON" posi-
tion.
Fuel filter indication lamp (die-
sel-powered vehicles)
This indication lamp illuminates when
the ignition switch is turned to the "ON"
position and goes off after the engine
has started. If it lights up while the en-
gine is running, it indicates that water
has accumulated inside the fuel filter; if
this happens, remove the water from the
fuel filter. Refer to "Removal of water
from the fuel filter (diesel-powered vehi-
cles only)" on page 6-06.
When the lamp goes out, you can re-
sume driving. If it either does not go out
or comes on from time to time, we rec-
ommend you to have the vehicle inspec-
ted.
E00509900239