Mitsubishi MOTORS PAJERO OBKE10E1 Owner's Manual page 70

Seat and seat belts
structions provided by the child restraint sys-
tem's manufacturer.
2
A- Connector
B- Slit
C- Vehicle seatback
D- Vehicle seat cushion
E- Lower anchorage
3. Remove the head restraint from the location
in which you wish to install a child restraint.
4. Open the cover from the tether anchorage in-
stallation point by pulling it back with your
hand as illustrated.
5. Latch the top tether strap hook (F) of the
child restraint system to the tether anchorage
2-32
bracket (G) and tighten the top tether strap so
it is securely fastened.
WARNING
l Do not latch the top tether strap hook to
any place, for example the luggage hook
(H), other than the tether anchorage
bracket (I), or the child restraint system
could not be fastened securely, resulting
in serious injury in the event of a collision.
6. Push and pull the child restraint system in all
directions to be sure it is firmly secured.
To remove
Remove the child restraint in accordance with the
instructions provided by the child restraint sys-
tem's manufacturer.
Installing a child restraint system to a
3-point type seat belt
E00408700428
3-door models
5-door models
Installation:
1. Fasten the seat belt to secure the child re-
straint system.
Make sure you hear a "click" when you in-
sert the latch plate in the buckle.
2. Remove all slack by using the locking clip.
3. Push and pull the child restraint in all direc-
tions to be sure it is secure.