Mitsubishi MOTORS PAJERO OBKE10E1 Owner's Manual page 169

NOTE
l
Immediately after reconnection of the battery
cable, the indication lamp will illuminate
and the Active Stability Control function will
stop operating. If the vehicle is driven and
the indication lamp goes off, the Active
Stability Control function will again start op-
erating.
If the indication lamp illuminates again or il-
luminates even though the battery has not
been disconnected, an insufficient battery
voltage or other problems may be the reason.
We recommend you to have your vehicle in-
spected.
Active traction control function
E00614100041
The active traction control function maintains trac-
tion on slippery road surfaces by automatically con-
trolling the engine output and applying the brakes
so the driving wheels are prevented from spinning.
The active traction control function automatically
turns ON when the ignition switch is turned to the
"ON" position.
CAUTION
l
If the temperature in the braking system
increases excessively due to continuous
brake control on a slippery road surface,
a warning buzzer will sound intermittent-
ly to warn the driver. If driving continues
in spite of the buzzer and the tempera-
ture in the braking system increases fur-
ther, the indication lamp will illumi-
nate, the warning buzzer will sound con-
tinuously for approximately 3 seconds,
and active traction control function oper-
ation will be suspended to protect the brak-
ing system. (Normal operation of the vehi-
cle will not be affected.) If the vehicle is
stopped and the indication lamp goes
off, the active traction control function
will start operating again.
Active traction control function indication lamp
E00614200097
The indication lamp (1) should illuminate when
the ignition switch is turned to the "ON" position
and should go off after a few seconds.
If the indication lamp stays on or does not illumi-
nate when the ignition switch is turned to the "ON"
position, we recommend you to have your vehicle
inspected.
Starting and driving
When the active Traction Control System operates,
the active traction control function indication lamp
(1) blinks and the indication lamp for the wheel (2)
being subjected to antispin control also blinks.
Example indication: Active traction control func-
tion controlling front-right wheel
NOTE
l
In the event of a fault in the Active Stability
Control function, the and indication
lamps illuminate. As a result, an indication
of the active traction control function is limi-
ted to flashing of the indication lamp for the
wheel (2) being subjected to antispin control.
4
4-43