Mitsubishi MOTORS PAJERO OBKE10E1 Owner's Manual page 31

NOTE
l The security alarm system can be activated
when people are riding inside the vehicle or
when the windows are open. To prevent acci-
dental activation of the alarm, do not set the
system to the system armed mode while peo-
ple are riding in the vehicle.
l With the system in the system armed mode,
if any method other than the keyless entry sys-
tem is used (namely a key or the central door
lock switch) to unlock the vehicle and open
any of the doors (including the backdoor),
the room lamp does not illuminate.
To activate and deactivate the vehicle inclination
detection function and the interior intrusion detec-
tion function
E00312100031
The vehicle inclination detection function and the
interior intrusion detection function can be deacti-
vated when parking in automated car parks or leav-
ing pets in the vehicle or leaving the vehicle with
the windows slightly open.
To deactivate the function
1. Remove the key from the ignition switch.
2. Raise and hold the wiper and washer switch
to the "MIST" position for approximately 3
seconds. The buzzer will sound once and the
function will be deactivated.
To activate the function
After deactivating the function, it will be activated
again using one of the following methods.
l Unlock the doors (including the backdoor) us-
ing the keyless entry system.
l Turn the ignition switch to the "ON" or
"ACC" position.
To activate the function again before locking the
doors (including the backdoor), raise and hold the
wiper and washer switch to the "MIST" position
for approximately 3 seconds.
Locking and unlocking
The buzzer will sound twice and the function will
be activated.
NOTE
l The sensitivity of the vehicle inclination de-
tection function and the interior intrusion de-
tection function can be adjusted. For further
details, please contact a MITSUBISHI
MOTORS Authorized Service Point.
Cancelling the system
E00301800399
The following methods can be used to cancel the
system when it is in the system preparation mode
or the system armed mode.
l Pressing the UNLOCK switch on the keyless
entry switch.
l Turning the ignition switch to the "ON" or
"ACC" position.
l Opening any one of the doors (including the
backdoor) when the system is in the system
preparation mode, or inserting the key into
the ignition switch.
1
1-13