Mitsubishi MOTORS PAJERO OBKE10E1 Owner's Manual page 100

Instruments and controls
To adjust the elevation
It is possible to adjust the currently indicated eleva-
tion using the following function buttons:
3
"+" - Adjustment of elevation
The elevation increases by 50 m (200 ft) ev-
ery time you lightly push the "+" button.
If you continue pressing the button for
about 2 seconds or more, the elevation indi-
cation is fast-forwarded. Then the setting
is changed to the elevation selected.
"-" - Adjustment of elevation
The elevation decreases by 50 m (200 ft)
every time you lightly push the "-" button.
If you continue pressing the button for
about 2 seconds or more, the elevation indi-
cation is fast-forwarded. Then the setting
is changed to the elevation selected.
3-18
NOTE
l
The elevation is determined from changes in
atmospheric pressure. Depending on weather
conditions, the indicated elevation may differ
from the actual elevation. Variations in atmos-
pheric pressure can cause different elevations
to be shown even in the same location. This
behavior does not indicate a fault. Use the in-
dication as a guide only.
Resetting the elevation
Press the "RESET" function button to reset the ele-
vation plotted in graph.
NOTE
l Pressing the "RESET" function button will
not reset the indication (C).
l It is possible to set the display unit to m or ft.
Refer to "User customization" on page 3-25.
Barometer
E00518700031
This display shows the atmospheric pressure at the
present location in (A). The atmospheric pressure
values are graphed every 5 minutes and the data for
up to 4 hours are shown in (B).
Resetting the atmospheric pressure
Press the "RESET" function button to reset the at-
mospheric pressure plotted in graph.