Reversing Sensor System - Mitsubishi MOTORS PAJERO OBKE10E1 Owner's Manual

Starting and driving
To resume the set speed
If the set speed driving is deactivated by the condi-
tion described in "To deactivate" on page 4-47,
you can resume the previously set speed by press-
ing the "ACC RES" switch (C) while driving at a
speed of about 40 km/h (25 mph) or higher.
4
Under either of the following conditions, however,
using the switch does not allow you to resume the
previously set speed. In these situations, repeat the
speed setting procedure:
l The "ON OFF" switch is pressed.
l The ignition switch is turned OFF.
l "CRUISE" indication lamp is turned OFF.
4-48

Reversing sensor system*

E00609800460
This system operates when you are backing the ve-
hicle. It uses corner and back sensors to detect an
obstacle and sounds a buzzer to inform you of the
approximate distance to the obstacle.
CAUTION
l The reversing sensor system assists you in
determining the approximate distance be-
tween the vehicle and an obstacle located
behind the vehicle. It has limitations in
terms of detectable areas and objects,
and may not properly detect some ob-
jects. Therefore, do not place excessive
confidence in the reversing sensor system
and operate the vehicle as carefully as
you would do with a vehicle not equipped
with this system.
l Make sure to check the surroundings
with your own eyes to ensure safety. Do
not operate the vehicle by relying on the
reversing sensor system alone.
Corner and back sensor locations
E00615500055
There are two corner sensors (A) at the corners of
the rear bumper, and two back sensors (B) in the
spare wheel garnish.
Obstacle detection areas
The detection areas of the corner and back sensors
are limited to those shown in the illustration. Be-
cause the back sensors are built in the overhanging
area of the vehicle (spare wheel garnish), the sen-
sors are unable to detect low or thin obstacles, or
obstacles on the bottom of the spare wheel garnish
or the bottom of the centre of the rear bumper.
Thus, make sure to check the surroundings as you
operate the vehicle in a safe manner.
Reversing sensor system detection areas
Depending on whether the vehicle is equipped with
a towing bar, you can change the reversing sensor
system between the standard mode and the towing
bar mode. The towing bar mode changes the sys-
tem to exclude the area in which the towing bar is
mounted from the detection areas.
E00618500014
E00615600261