Mitsubishi MOTORS PAJERO OBKE10E1 Owner's Manual page 150

Starting and driving
CAUTION
l
Do not drive your vehicle in the "4HLc"
or "4LLc" position on dry paved roads
and highways. Doing so may result in ex-
cessive tyre wear, increased fuel consump-
tion, and possible noise generation. It
may also increase the differential oil tem-
perature, which may damage the drive sys-
tem. Further, the drive train will be sub-
jected to excessive loading, resulting in oil
leakage, component seizure, or other seri-
ous problems. On dry paved roads and
highways, drive the vehicle in "2H" or
"4H" only.
To shift from To
4
2H 4H
4H 2H or 4HLc
4HLc 4H
4HLc 4LLc
4LLc 4HLc
NOTE
l Shifting of the lever among "2H" ↔ "4H"
↔ "4HLc" should only be done at speeds be-
low 100 km/h (62 mph).
4-24
Transfer shift lever operation
The transfer shift lever is operated by pushing it
down and sliding it to the desired position.
Vehicles with M/T
The transfer shift lever can be operated while the vehicle is
either moving or stationary.
When the vehicle is not in motion, shift the gearshift lever
to the "N" (Neutral) position before operating the transfer
shift lever.
When the vehicle is moving, and only while it can be
steered straight ahead, and release the accelerator pedal be-
fore operating the transfer shift lever.
Stop the vehicle, depress the clutch pedal to the floor and
operate the transfer shift lever.
Keep depressing the clutch pedal while the 2WD/4WD op-
eration indication lamp continues to blink.
E00605900072
Procedure
Vehicles with A/T
The transfer shift lever can be operated while the vehicle
is either moving or stationary.
When the vehicle is not in motion, shift the selector lever
to the "N" (NEUTRAL) position before operating the
transfer shift lever.
When the vehicle is moving, and only while it can be
steered straight ahead, shift the selector lever to the "D"
(DRIVE) position, and release the accelerator pedal be-
fore operating the transfer shift lever.
Stop the vehicle, shift the selector lever to the "N" (NEU-
TRAL) position, and operate the transfer shift lever.