Mitsubishi MOTORS PAJERO OBKE10E1 Owner's Manual page 32

Locking and unlocking
NOTE
l
If the bonnet is opened during the system prep-
aration mode, the system preparation mode
is suspended. The system returns to the sys-
tem preparation mode when the bonnet is
closed.
l If the battery terminals are disconnected
while the system is in the system preparation
1
mode, the memory will be erased.
l It is possible to register up to 4 remote con-
trol switches.
As long as they are registered, any of the 4
remote control switches, other than the one
used to activate the system, can be used to
cancel the system.
If you want to register additional remote con-
trol switches, please contact a MITSUBISHI
MOTORS Authorized Service Point.
l The activation distance for keyless entry sys-
tem is approximately 4 m.
If it is not possible to lock or unlock the vehi-
cle by pressing the switch at the correct dis-
tance or the security alarm system cannot be
set or cancelled using the switch, the battery
may need to be replaced.
For further information, please consult a
MITSUBISHI MOTORS Authorized Service
Point.
If you replace the battery yourself, refer to
"Procedure for replacing the remote control
switch battery" on page 1-05.
1-14
l If the UNLOCK switch is pressed and no
door is (including the backdoor) opened with-
in 30 seconds, the doors will automatically re-
lock. In this case as well, the system prepara-
tion mode will go into effect.
The time between pressing the UNLOCK
switch and automatic locking can be adjus-
ted. Please consult a MITSUBISHI
MOTORS Authorized Service Point.
Alarm activation
E00301900550
When the system is in the system armed mode, the
alarm will be activated as follows if the vehicle is
unlocked and any of the doors (including the back-
door) or bonnet is opened using a method other
than pressing the UNLOCK switch on the keyless
entry switch.
1. The alarm will be activated for approximate-
ly 30 seconds.
The turn-signal lamps will blink, and the si-
ren will sound intermittently.
2. The alarm will resume if unlawful actions
are taken again, even if the alarm has stopped.
NOTE
l
The interior lamp will not come on while the
alarm is sounding.
Cancelling the alarm
E00302000356
It is possible to halt the activation of an alarm us-
ing the following methods:
l Pressing the LOCK or UNLOCK switch on
the keyless entry switch.
(After pressing the LOCK switch, the vehi-
cle will lock if all the doors (including the
backdoor) are closed, after which the system
preparation mode will once again go into ef-
fect.)
l Turning the ignition switch to the "ON" or
"ACC" position.
NOTE
l When the ignition switch is turned to the
"ON" position, the buzzer sounds 4 times.
This operation indicates that the alarm was ac-
tivated while the vehicle was parked.
Please check the inside of the vehicle to con-
firm that nothing was stolen.
l
Even if the battery is disconnected, the alarm
activation memory will not be erased.