Table of Contents
Advertisement
Maintenance
Headlamps
Replacement of high-beam
1. Remove the bulb and connector assembly
(A) by turning it anticlockwise.
2. Depress the tab (B) on the harness connector
and pull the harness connector (C) to remove
it.
8
3. To install the bulb, perform the removal
steps in reverse.
8-24
Replacement of low beam (except for vehicles
with discharge headlamps)
E01003501199
1. Remove the bulb and connector assembly
(A) by turning it anticlockwise.
2. Depress the tab (B) on the harness connector
and pull the harness connector (C) to remove
it.
3. To install the bulb, perform the removal
steps in reverse.
CAUTION
l
Handle halogen lamp bulbs with care.
The gas inside halogen lamp bulbs is high-
ly pressurized, so dropping, knocking, or
scratching a halogen lamp bulb can cause
it to shatter.
l
Never hold the halogen lamp bulb with a
bare hand, dirty glove, etc.
The oil from your hand could cause the
bulb to break the next time the head-
lamps are operated. If the glass surface is
dirty, it must be cleaned with alcohol,
paint thinner, etc., and refit it after dry-
ing it thoroughly.
Position lamps
E01003700471
1. Turn the bulb socket anticlockwise to re-
move it.
Advertisement
Chapters
Table of Contents
