Mitsubishi MOTORS PAJERO OBKE10E1 Owner's Manual page 30

Locking and unlocking
you, press the UNLOCK switch (A) on the
keyless entry switch to select the security
alarm settings mode.
1
The settings mode can be toggled by press-
ing the UNLOCK switch. The mode can be
confirmed from the number of times the buz-
zer sounds.
Number of times
Security alarm settings mode
the buzzer sounds
1 Alarm inactive
3 Alarm active
6. Any of the following operations can be used
to terminate the system settings change mode.
l Releasing the windscreen wiper and wash-
er switch.
l Closing the driver's door.
l Inserting the key into the ignition switch.
l Placing the lamp switch in any position
other than "OFF".
l Allowing 30 seconds to pass without mak-
ing any changes to the settings.
1-12
NOTE
l
If anything with regard to making changes to
the security alarm system settings is hard to
understand, please consult a MITSUBISHI
MOTORS Authorized Service Point.
l Avoid leaving valuable items inside the vehi-
cle even when the security alarm system has
been set to the "active" mode.
Setting the system
E00301700503
Once the security alarm system has been set to the
"active" mode, follow the procedure below to set
the system to the system armed mode.
1. Remove the key from the ignition switch.
2. Exit the vehicle and close all of the doors (in-
cluding the backdoor) and the bonnet.
3. Press the LOCK switch (A) on the keyless en-
try switch in order to lock all the doors (in-
cluding the backdoor).
By locking the vehicle using the keyless en-
try system, the system preparation mode is ac-
tivated. The buzzer sounds intermittently for
confirmation, and the security alarm indica-
tor (B) on the instrument panel blinks.
NOTE
l The system preparation mode is not activated
when all of the doors (including the back-
door) have been locked using a method other
than the keyless entry system (namely a key
or the central door lock switch).
l If the bonnet is open, the security alarm indi-
cator illuminates, and the system does not en-
ter the system armed mode. When the bonnet
is closed, the system enters the system prepa-
ration mode, and after approximately 20 sec-
onds, the system enters the system armed
mode.
4. The buzzer stops after approximately 20 sec-
onds, and when the blinking of the security
alarm indicator starts to slow down, the sys-
tem armed mode goes into effect. The securi-
ty alarm indicator continues to blink during
the system armed mode.