Mitsubishi MOTORS PAJERO OBKE10E1 Owner's Manual page 178

Starting and driving
Location of rear-view camera
The rear-view camera (A) is integrated into the
spare wheel garnish.
Range of view of rear-view camera
4
4-52
How to use the rear-view camera
When you place the shift lever in the "R" (Re-
verse) position (on vehicles with M/T) or selector
lever in the "R" (REVERSE) position (on vehicles
with A/T) with the ignition switch in the "ON" po-
sition, the view behind the vehicle will automatical-
ly appear on the screen of the MITSUBISHI Multi
Communication System (MMCS). When you move
the shift lever or selector lever to any other posi-
tion, the screen will return to its original indication.
NOTE
l The buzzer that sounds while the vehicle is re-
versing indicates that the selector lever is in
the "R" (REVERSE) position. It does not
warn of an obstacle behind the vehicle (on ve-
hicles with A/T).
l If you press any of the buttons on the MMCS
control panel while the screen is showing the
view from the rear-view camera, the screen
indication will change to the one for that but-
ton.
Example of rear-view camera screen indication
The lines (F and G) in the view from the rear-view
camera have the meanings shown below. Please
use them as guides.
l
Red: The point approximately 50 cm behind
the vehicle
l Green: The point approximately 20 cm be-
yond the width of the vehicle on either side
A- Rear extremity of the rear bumper
B- Spare wheel garnish
C- Approx. 20 cm
D- Approx. 50 cm
E- Approx. 1 m
F- Line (red)
G- Line (green)