Cigarette Lighter; Accessory Socket - Mitsubishi MOTORS PAJERO OBKE10E1 Owner's Manual

Table of Contents

Advertisement

For pleasant driving

Cigarette lighter*

The cigarette lighter can be used while the ignition
switch is in the "ON" or "ACC" position.
1- Open the lid
2- Push all the way in.
The cigarette lighter will automatically return to its
original position with a "click" when ready. Pull it
5
out for use.
After use, insert the cigarette lighter to its original
position in the socket.
NOTE
l
Do not leave the cigarette lighter removed
from its socket, because the socket might be-
come clogged by foreign material and be
short-circuited.
5-110
CAUTION
E00711501042
l
Do not touch the heating element or the
cigarette lighter housing, hold the knob
only to prevent burns.
l
Do not allow children to operate or play
with the cigarette lighter as burns may oc-
cur.
l
Something is wrong with the cigarette
lighter if it does not pop back out within
approximately 30 seconds of being push-
ed in. We recommend you to have it
checked.
l
Do not use any electric appliance that is
not
approved
by
MOTORS. Doing so could damage the
socket. If you used the cigarette lighter af-
ter damaging the socket, the cigarette
lighter might pop out or fail to come out
after being pushed in.
l
When the cigarette lighter socket is used
as a power source for an electric appli-
ance, be sure that the electric appliance
operates at 12 V and has an electric ca-
pacity of 120 W or less. In addition, long
use of the electric appliance without run-
ning the engine may run down the battery.

Accessory socket

The accessory socket can be used while the igni-
tion switch is in the "ON" or "ACC" position.
CAUTION
l
Be aware that using electronic equipment
with the engine off may run the battery
down.
l
When you connect an electrical device,
make sure it is rated at 12 V and its elec-
trical capacity does not exceed 120 W.
When using some sockets at the same
MITSUBISHI
time, make sure the total power consump-
tion of the electrical accessories does not
exceed 120 W at 12 V.
l
When the accessory socket is not in use,
be sure to close the cap or plug, because
the socket might become clogged by for-
eign material and be shortcircuited.
NOTE
l
The two or more accessory sockets can be
used simultaneously.
E00711600987

Advertisement

Table of Contents
loading

Table of Contents