Mitsubishi MOTORS PAJERO OBKE10E1 Owner's Manual page 198

For pleasant driving
To listen to the radio
1. Press the PWR button (2) to turn the audio
system on and off.
2. Press the AM/FM button (1) to select the de-
sired band.
3. Press the TUNE button (6 or 7) or SEEK but-
ton (4 or 5) to tune to a station, or press one
of the memory select button (3) to recall a sta-
tion memorised for that button.
To tune the radio
Automatic tuning
After pressing the SEEK button (4 or 5), the selec-
ted station reception will start.
Manual tuning
The frequency changes every time the TUNE but-
ton (6 or 7) is pressed. The frequency changes con-
tinuously if you keep pushing the button. Press the
button to select the desired station.
5
5-16
To enter frequencies into the memory
E00709000388
Manual setting
You can assign to the memory select buttons (3) a
maximum of 18 stations in the FM band (6 FM1,
6 FM2 and 6 FM3 stations) and 6 stations each in
the MW and LW band. (Stations already assigned
to the memory select buttons are replaced by any
newly assigned stations.)
E00709100318
Follow the steps described below.
1. Press either the TUNE button (6 or 7) to tune
the frequency to be entered in the memory.
2. Press one of the memory select buttons (3)
for 2 seconds or longer. The sound will be
momentarily interrupted while the frequency
is being entered into the memory.
The number of the button corresponding to
the entry in the memory and the frequency
are displayed.
3. The preset memory setting is retrieved by
pressing the button for less than 2 seconds.
Automatic setting
E00716101001 With the method, all manually set stations in the
band currently selected for reception are replaced
with stations in the same band that are automatical-
ly selected in order of signal strength. The radio au-
tomatically selects 6 stations in the FM band (FM3
station only) and 6 stations each in the MW and
LW band.
Follow the steps described below.
1. With the radio mode selected, hold down the
AM/FM button (1) for 2 seconds or longer.
The 6 stations with the best signal strength
will automatically be assigned to the memo-
ry select buttons (3), with the lowest-frequen-
cy station being assigned to the lowest-num-
ber button.
2. When you subsequently press a memory se-
lect button to select a channel number, the ra-
dio will begin receiving the station assigned
to that number.
NOTE
l If you press the AM/FM button (1) for
2 seconds or longer while tuning in the FM1
or FM2 band, the radio will automatically
switch to the FM3 band, where the automatic
seeking/storing will be activated.