Technical Data - Otto Bock 13E205 Instructions For Use Manual

9CleaningandCare
Clean the product with a damp, soft cloth and mild soap (e.g. Ottobock 453H10=1 Derma Clean)
when needed. Ensure that no liquid penetrates into the system component.
Then, dry the prosthesis component with a soft cloth.
10TechnicalData
Power supply
Static current
Operating temperature range
Storage and transport in original
packaging
Storage and transport without
packaging
Relative humidity
Power off
Weight
Service life
11Liability
Otto Bock Healthcare Products GmbH, hereafter referred to as manufacturer, assumes liability
only if the user complies with the processing, operating and maintenance instructions as well
as the service intervals. The manufacturer explicitly states that this product may only be used in
combination with components that were authorized by the manufacturer (see instructions for use
and catalogs). The manufacturer does not assume liability for damage caused by component
combinations which it did not authorize.
The product may only be opened and repaired by authorized Ottobock technicians.
12CEconformity
This product meets the requirements of the 93/42/EWG guidelines for medical products. This
product has been classified as a class I product according to the classification criteria outlined
in appendix IX of the guidelines. The declaration of conformity was therefore created by Ottobock
with sole responsibility according to appendix VII of the guidelines.
26 | Ottobock
757B20 Ottobock EnergyPack (7.2 V)
757B21 Ottobock EnergyPack (7.2 V)
757B25=* MyoEnergy Integral (7.4 V)
757B35=* MyoEnergy Integral (7.4 V)
757B15 Ottobock X-ChangePack (6 V)
1 mA
0 °C – +70 °C
-20 °C – +40 °C
-20 °C – +40 °C
80% nicht kondensierend
load dependent between 30 ms and 10 s
10 g
5 years
13E205