Safety Instructions; Basic Safety Information; Prerequisites; Connecting The Unit - Dentsply Sirona Primescan Connect Operating Instructions Manual

2 Safety instructions

2.1 Basic safety information

12
2 Safety instructions
2.1 Basic safety information
2.1.1

Prerequisites

NOTE
Important information on building installation
In order to prevent the risk of an electric shock, this unit must only be
connected to a supply mains with a ground wire.
The building installation must be performed by a qualified expert in
compliance with the national regulations.
NOTE
Restrictions regarding installation site
The system is not intended for operation in areas subject to explosion
hazards.
NOTE
Do not damage the unit!
The unit can be damaged if opened improperly.
It is expressly prohibited to open the unit with tools!
2.1.2

Connecting the unit

Perform connection by following the directions given in the present
operating instructions.
2.1.3

General safety information

CAUTION
Risk group 2: Potentially hazardous optical radiation!
Direct radiation to the eye can be harmful to the eye.
➢ During operation, do not look directly at the lamp for long periods.
CAUTION
Note on the prevention, recognition, and elimination of unintended
electromagnetic effects:
The Primescan Connect acquisition unit is Class B equipment
(classified according to CISPR 11, EN 60601-1-2: 2015 based on IEC
60601-1-2: 2014).
This unit may be used in professional equipment of health services.
NOTE
Install only approved software
To prevent interference with the runtime reliability of the program,
only software approved by Dentsply Sirona may be installed.
Dentsply Sirona
Operating Instructions Primescan Connect
67 97 216 D3801
D3801.201.01.03.02 2022-09