System Controls; Single Ups Operation - Eaton 93PM Installation And Operation Manual

7 7 . . 2 2 . . 8 8 S S y y s s t t e e m m C C o o n n t t r r o o l l s s
Tap the CONTROLS tab on the main menu navigation bar to display the Controls screen. Double conversion
operation, transfer to bypass, shutdown, and charger control commands are controlled through this screen. In
addition, the screen displays the current status of the UPS.
Table 34 describes the control functions and provides instructions to access and use the command menu
screens.
Table 35 lists the typical System Status Screen Messages that are displayed during UPS operation.
For UPS operating instructions using the System Controls, see paragraph
Figure 61 through Figure 65
Table 34. Controls Menu Operation
Function Subfunction
System
Controls
System Status
Bypass
Charger
Battery Test
Table 35. Typical System Status Messages
Function
UPS
Bypass
Charger
Eaton 93PM UPS (400V/480V Four-Wire – 100 kW Frame) Installation and Operation Manual 164000566—Rev 04
show the major control screens.
Operation
The CONTROLS tab on the main menu navigation bar displays the
System Controls screen.
GO ONLINE starts the UPS in Double Conversion mode or transfers the
UPS to Double Conversion mode from Bypass mode.
GO TO BYPASS starts the UPS in Bypass mode or transfers the UPS
to Bypass mode from Double Conversion mode.
TURN ON CHARGER/TURN OFF CHARGER sets the battery charger
on or off.
RUN BATTERY TEST starts the battery test.
Message
Double Conversion; Bypass; ESS
Off; On; Available
Charger Resting; Charger
UPS Operating Instructions
7.3 Single UPS Operation.
109