Eaton 93PM Installation And Operation Manual page 81

93PM Universal Integrated Battery Cabinet Installation Manual-Large and Large High Rate, listed in
paragraph 1.8 For More
9. Proceed to Step 11.
10. Top Entry Wiring. Route the battery shunt trip wiring from the battery cabinet or battery disconnect
through the top of the UPS sidecar and the bottom UPS inter-cabinet wiring access pass-through and static
switch shelf bushing to the UPS battery shunt trip terminals. See
access information, and
Integrated Battery Cabinet Installation Manual-Large and Large High Rate or the Eaton 93PM Universal
Integrated Battery Cabinet Installation Manual-Large and Large High Rate, listed in paragraph
1.8 For More Information, for battery cabinet wiring access information and instructions.
11. Connect the wiring to the battery shunt trip terminals. See paragraph
3.2.4 UPS System Interface Wiring Preparation
Figure 30 for terminal assignments.
12. If wiring generator interface connections, proceed to paragraph
wiring external parallel CAN connections, proceed to paragraph
4.7.5 Installing External Parallel CAN Control Wiring and
connections, proceed to paragraph
4.7.6 Installing External Parallel Pull Chain Control Wiring and
proceed to paragraph 4.7.7 Installing Minislot Interface
to paragraph 4.8 Installing a REPO
13. Reinstall all safety shield panels previously removed and secure with the retained hardware.
14. If removed, reinstall the sidecar front panel and secure with the retained hardware.
15. Close the UPS outside door and secure the latch.
Eaton 93PM UPS (400V/480V Four-Wire – 100 kW Frame) Installation and Operation Manual 164000566—Rev 04
Information, for battery cabinet wiring access information and instructions.
Figure 28 and Figure 29 for UPS terminal locations. Refer to the Eaton 93PM
and
Switch; otherwise, proceed to Step 13.
Figure 18 and
Table 26 for wiring and termination requirements, and
4.7.4 Generator Interface
Connections; if wiring external parallel pull chain
Connections; if wiring Minislot connections,
Connections; if wiring REPO connections, proceed
UPS System Installation
Figure 19 for UPS wiring
Connections; if
71