System Controls - Eaton 93E Installation And Operation Manual

Figure 41.Typical initial setup screen
7.2.7
To display the Controls screen, select the CONTROLS symbol in the
main menu bar and press the
to control the normal operation, transfer to bypass, load off, and charger
control commands. In addition, the screen displays the current status of
the UPS. Figure 42 shows the System Control screen.
Use the
then press the
Use the
Table 16 describes the control functions and provides instructions on
how to access and use the command menu screens.
Table 17 lists typical system status screen messages that are displayed
during the UPS operation.
Figure 42.Typical system control screen
© Eaton Corporation plc 2015. All rights reserved.
Eaton 93E UPS 15-80 kVA (380/400/415 V)

System controls

or push button to highlight the desired command screen,
push button to display the command menu screen.
or push button to highlight the desired command.
push button. Use the Controls screen
Revision: 001
Document ID: 614-01975-00
Installation and Operation Manual
97 (133)