System Controls - Eaton 93E G2 100/100 User And Installation Manual

Eaton 93E Generation 2 UPS 100-200 kVA
(380/400/415V)
Figure 38. Typical initial setup screen
7.2.7
To display the Controls screen, select the CONTROLS symbol in the main menu
bar and press the
normal operation, transfer to bypass, load off, and charger control commands. In
addition, the screen displays the current status of the UPS. Figure
System Control screen.
Use the
press the
Use the
22
Table
access and use the command menu screens.
For detailed information about using the System Controls, see Section
©
Eaton Corporation plc 2019. All rights reserved.

System controls

push button. Use the Controls screen to control the
or push button to highlight the desired command screen, then
push button to display the command menu screen.
or push button to highlight the desired command.
describes the control functions and provides instructions on how to
Revision: 002 Document ID: P-164000848
User's and installation guide
39
shows the
7.3
.
86 (118)