Eaton 93PM Installation And Operation Manual page 60

UPS Installation Plan and Unpacking
3 3 . . 3 3 I I n n s s p p e e c c t t i i n n g g a a n n d d U U n n p p a a c c k k i i n n g g t t h h e e U U P P S S C C a a b b i i n n e e t t s s
The cabinet is shipped bolted to a metal and wood pallet (see
packaging material covering the cabinet.
NOTE
The UPS cabinet is heavy (see
cabinet may tip and cause serious injury.
1. outer packaging for evidence of damage during transit.
Do not install a damaged cabinet. Report any damage to the carrier and contact an Eaton service representative
immediately.
NOTE
2. Use a forklift or pallet jack to move the packaged cabinet to the installation site, or as close as possible,
before unpacking. If possible, move the cabinet using the pallet. Insert the forklift or pallet jack forks
between the supports on the bottom of the pallet (see
gravity measurements).
Do not tilt the UPS cabinet more than 10° from vertical or the cabinet may tip over.
3. Set the pallet on a firm, level surface, allowing a minimum clearance of 3m (10 ft) on each side for
removing the cabinet from the pallet.
4. Remove the protective packaging material from the cabinet and recycle in a responsible manner. Retain
any parts kits packaged with the cabinet.
5. Inspect the contents for any evidence of physical damage, and compare each item with the Bill of Lading.
If damage has occurred or shortages are evident, contact an Eaton service representative immediately to
determine the extent of the damage and its impact on further installation.
NOTE
50 Eaton 93PM UPS (400V/480V Four-Wire – 100 kW Frame) Installation and Operation Manual 164000566—Rev 04
Startup and operational checks must be performed by an authorized Eaton Customer
Service Engineer, or the warranty terms specified in
This service is offered as part of the sales contract for the UPS. Contact an Eaton service
representative in advance (a minimum two-week notice is required) to reserve a
preferred startup date.
Table 3). If unpacking and unloading instructions are not closely followed, the
For the following step, verify that the forklift or pallet jack is rated to handle the weight
of the cabinet (see Table 3
While waiting for installation, protect the unpacked cabinet from moisture, dust, and
other harmful contaminants. Failure to store and protect the UPS properly may void the
warranty.
Figure 12 or Figure
Chapter 11 Warranty
WARNING
CAUTION
for cabinet weight).
Figure 8 or Figure 9
CAUTION
13) with outer protective
become void.
for the UPS cabinet center of