Tandem Tray Side Registration - Ricoh MP 7503SP Field Service Manual

• To use the paper tray for A4 size, set the screw in the left hole as shown.
• For LT size, the screw should be placed on the right.
14. Reinstall the rear bottom plate.
15. Enter the new paper size with SP5959-001 (Paper Size – Tray 1).
16. Do the printer adjustments. page 985

Tandem Tray Side Registration

Normally the side registration of the image can be adjusted in the SP mode.
• If the punch hole positions are not aligned from a particular feed station, however, you can
manually adjust the side registration by changing the tray cover position for that tray.
• Next, you can adjust the side registration of the image. page 985
1. Pull out the tray and remove the right inner cover [A] (
2. Loosen the screws and adjust the position of the plate [B].
• Adjustment range: 0 ± 2.0 mm adjustment step: 1.0 mm/step
x 2).
Paper Feed Units
773