Discharge Plate - Ricoh MP 7503SP Field Service Manual

Discharge Plate

1. Remove the transfer belt unit Transfer page 674
• It is not necessary to remove the transfer belt assembly. However, work carefully to avoid
scratching the surface of the belt.
2. Remove the shoulder screw and spring [A].
3. Rotate the discharge unit [B] up, and then raise it off.
4. Disconnect three tabs [1], [2], [3].
5. Remove small bracket [C].
6. Open the case [D].
7. Remove discharge plate [E].
• At re-installation make sure that the discharge plate is perfectly flat before you re-assemble
the case.
Transfer Belt Unit
685