Ricoh MP 7503SP Field Service Manual page 869

• Special Destination List: Fax Initial Setting > Receive Setting > Special Destination Setting: List
Print > Print
• Fax Initial Setting >Receive Settings > Onscreen items and settings
• Fax Initial Setting > Send Settings > Onscreen items and settings
11. Turn the machine off and then disconnect it from its power source.
12. Remove the SD card with the Address Book data from SD Card Slot 2.
13. Remove the controller board and lay it on a flat clean surface.
14. Remove both NVRAMs from the old controller board and replace them with the new NVRAMs.
• The controller board has two NVRAMs, 2M-1 and 2M-2.
• These NVRAMs are always replaced as a set.
• Each NVRAM must be installed at the correct location as shown above.
• If their positions are reversed, this will cause a short circuit and damage the board and
NVRAMs.
15. Reinstall the controller board in the machine.
16. Reconnect the machine, confirm that there are no SD cards in the machine, and then turn the
machine on.
• If the machine issues SC995-02 (CPM Setting Error 2), do not turn the machine off. Ignore this
message and continue this procedure.
17. Insert into SD Card Slot 2 the SD card with the NVRAM data that you copied earlier with SP5824.
18. Do SP5825 (NVRAM Data Download) to copy the data from the SD card to the new NVRAM on
the controller board.
• The download will take about 2 or 3 min.
PCBs, HDD
867