Side-To-Side Registration Adjustment - Ricoh Robin Service Manual

COPY QUALITY ADJUSTMENT

8.14 SIDE-TO-SIDE REGISTRATION ADJUSTMENT

When:
Purpose:
Adjustment
Standard:
How to Adjust:
How it works:
NOTE: a) When side-to-side registration is out of the adjustment
standard only for the paper tray, adjust the side fence position
in the paper tray.
b) When side-to-side registration is out of the adjustment
standard for both the paper tray and the by-pass feed table,
adjust the lens position. Check the adjustment by making a
copy from the by-pass feed table. Then, make a copy from the
paper tray and adjust the side fence position in the paper tray
if necessary.
– Side Fence Adjustment (Paper Tray) –
[A]
[C]
1. Pull the paper tray out.
2. Move the side fences to the widest position.
3. Remove the bottom plate spacer [A].
4. Slide the bottom plate [B] to the front side and remove it.
5. Remove two springs [C].
Side-to-side registration is out of the adjustment
standard.
To maintain the proper side-to-side registration
0 ± 2 mm (0 ± 0.08")
1. Change the lens position.
2. Change the side fence position in the paper tray.
Shifts the copy image.
5-84
24 June 1994
[B]