Ptl (Pre-Transfer Lamp) - Ricoh MP 7503SP Field Service Manual

Drum Unit
13. After replacing the drum, do SP2962 (Adjustment of Drum Conditions).

PTL (Pre-Transfer Lamp)

1. Remove the drum unit and drum. page 582
2. The PTL bracket is held in place by two screws [A] and [B]. Screw [B] is a shoulder screw. This
screw must be installed at the same position.
3. At the front [A] pass the end of the screwdriver under the shaft arm to remove the screw.
4. Do not place the screwdriver on top of the arm [B] to remove the screw.
5. At the rear [A] pass the screwdriver under the unit to remove the screw.
6. Do not place the screwdriver on top of the plate [B] to remove the screw.
587