Changing The Default Terminal - Data I/O UniSite-xpi User Manual

Changing the
Default Terminal
UniSite-xpi User Manual
2. The programmer then displays the default and current terminal types
and a list of the available terminal types. To select a new terminal
type, enter the number corresponding to that terminal type and press
E .
NTER
Note: If the screen is blank or if random characters appear after you press Enter,
the Terminal type configuration is incorrect. Switch the power off and
then power up the programmer. Then return to the beginning of this
section and select the proper terminal type.
If you do not see your terminal listed on the screen and do not know
what terminal type(s) it can emulate, refer to the Compatible
Terminals list shown previously in this chapter.
After you have changed the terminal type for this current session, the
programmer responds with the following prompt:
Save terminal type as power on default? (Y/N) [N]
3. Press N, E to go to the Main Menu without changing the default
NTER
terminal type.
When the Main Menu appears, the programmer is ready for operation.
Go to the section titled "Insert Algorithm Disk."
Follow the steps below to change the default terminal type.
1. At the bottom of the Power-on screen, the programmer displays the
following prompt:
Do you want to select a new terminal type? (Y/N) [N]:
Press Y, E to select a new terminal type.
NTER
2. The programmer then displays the default and current terminal types
and a list of the available terminal types. To select a new terminal
type, enter the number corresponding to that terminal type and press
.
E
NTER
Note: If the screen is blank or if random characters appear after you press Enter,
the Terminal type configuration is incorrect. Switch the power off and
then power up the programmer. Then return to the beginning of this
section and select the proper terminal type.
If you do not see your terminal listed on the screen and do not know
what terminal type(s) it can emulate, refer to the Approved
Terminals list shown previously in this chapter.
After you have changed the terminal type for this current session, the
programmer will respond with the following prompt:
Save terminal type as power on default? (Y/N) [N]
3. Press Y, E to change the default terminal type. After the
NTER
programmer saves the currently selected terminal type as the
power-on default, the Main Menu appears, indicating that the
programmer is ready for operation. Go to the section titled "Insert
Algorithm Disk."
2. Setup and Installation
2-23