Data I/O UniSite-xpi User Manual page 31

2. Setup and Installation
UniSite-xpi User Manual
This chapter describes how to set up UniSite-xpi and get it working with
your equipment. Before you read this chapter, make sure you have read
Chapter 1, "Introduction."
This chapter guides you through configuring the hardware and installing
the system software. The process is divided as follows:
1. Install a Module .......................................................... 2-3
2. Check the Line Voltage (on older units) ................. 2-5
3. Choose Your Configuration...................................... 2-5
4. Connect Your Equipment.......................................... 2-6
5. Install the Base .......................................................... 2-15
6. Power Up the Programmer..................................... 2-16
7. The Power-on Screen ............................................... 2-22
8. Insert the Algorithm Disk(s) ................................... 2-24
The following steps are optional, depending on your programmer
configuration.
9. Update System Software ......................................... 2-24
10. Set Up High Speed Download ............................... 2-26
11. Install and Update the MSM .................................. 2-29
When you have finished with steps 1 through 8 and any optional steps 9
through 11, do the following:
• Refer to step 12, "Install Devices," on page 2-30 for instructions on
how to install devices.
• Refer to the "What to Do Next Time" section on page 2-41 for
instructions on what to do next time you powerup your programmer.
The following maintenance information is also included:
• Changing the Line Voltage (on older units) ......... 2-39
• Replacing the Line Fuse........................................... 2-40
2-1