Data I/O UniSite-xpi User Manual page 313

7. Messages
Insert algorithm disk.
This message will appear during the Select device operation if the algorithm file is not present on the
selected drive. Check the "Algorithm type" and "Algorithm media" settings.
Insert a disk containing the appropriate type of algorithms.
This message will also appear in the following situations:
4) The programmer needs adapter information when a device operation is attempted using the PPI base.
5) When attempting to view device specific information if the algorithm disk is not present. In this case,
insert the algorithm disk, select the device again, and then view the device-specific information.
Insert Algorithm Set 1 disk.
This message will appear if you attempt to select a device from Algorithm Set 1 and the disk is not present.
Insert the Algorithm Set 1 disk. Press return to perform the operation again.
Insert Algorithm Set 2 disk.
This message will appear if you attempt to select a device from Algorithm Set 2 and the disk is not present.
Insert the Algorithm Set 2 disk. Press return to perform the operation again.
Insert Algorithm Set 3 disk.
This message will appear if you attempt to select a device from Algorithm Set and the disk is not present.
Insert the Algorithm Set 3 disk. Press return to perform the operation again.
Insert blank device. Hit return.
This message appears during a Quick Copy operation. Remove the newly programmed device or the
master device from the device socket, place a blank device in the socket and press E . UniSite-xpi will
NTER
then begin programming the blank device with RAM data loaded from the master device.
Insert blank device. Hit return to continue or push START lever forward.
(Legacy) This message appears during a Quick Copy operation if you are using the SetSite module. Place
the blank devices into the SetSite sockets, lock them into place, and press E or move the socket lever
NTER
to the START position. UniSite will then start to program the parts with data from RAM.
Insert Boot Files disk.
The programmer needs the Boot Files disk present in order to access a file which is on that disk. Insert the
Boot Files disk.
Insert Custom Menu algorithm disk.
This message will appear during the Select device or Custom Menu algorithm building operation if the
Custom Menu algorithm disk is not present on the selected drive. Check "Algorithm type" and
"Algorithm media" settings.
Insert destination disk. Hit return to continue.
This message may appear during the Duplicate Disk or Copy File operation. When this message appears,
remove the source disk, insert the destination disk (the disk where you want the data to go) and press
E . Make sure to use a formatted disk. If you insert an unformatted disk, UniSite-xpi will abort the
NTER
operation and display "Sector not found." If this occurs, perform the Format Disk operation and restart the
Duplicate Disk or Copy File operation.
UniSite-xpi User Manual 7-17