Table of Contents
Advertisement
Additional Information
UniSite-xpi User Manual
This error is reported by the hardware overcurrent detection circuitry
on the programmer. The trip level for the overcurrent error is set by the
programming algorithm. From the error alone, it is not possible to
determine which operation the programmer was performing (device
tests, program, verify/read) when the overcurrent condition was
detected. To determine the nature of the problem, you need to isolate
the operation that is being performed.
7. Messages
7-43
Advertisement
Table of Contents
Need help?
Do you have a question about the UniSite-xpi and is the answer not in the manual?
Questions and answers