Crc Default Settings - Data I/O UniSite-xpi User Manual

CRC Default Settings

UniSite-xpi User Manual
When CRC mode is entered, certain defaults are set prior to accepting any
commands. The default settings are outlined below:
Description
Upload/download port
Data source/destination
Security fuse data (0 or 1)
Program security fuse
Reject option (commercial or single)
Algorithm Source
Logic verification option
Number of verify passes (0, 1, or 2)
Fill RAM before downloading
Illegal bit check option
Blank check option
Enable yield tally option
EE bulk erase option
Odd/even byte swap for 16 bit option
JEDEC I/O translate DIP/LCC option
Continuity check option
Compare electronic signature
Host command
I/O address offset
I/O format
Instrument control code (0, 1, 2)
I/O timeout
Upload wait
Number of nulls
Serial set auto-increment mode
Programming mode
Total set size
Upload EOF delimiter flag
Download EOF delimiter flag
If you exit remote mode using the Z, E
S +Z + E ), UniSite-xpi's parameters are set to what they were
HIFT NTER
before you entered remote mode.
5. Computer Remote Control
Setting
Remote port
RAM
0
No
Commercial
D (standard algorithms)
All
2
No
No
No
No
No
No
Yes
Yes
Yes
Blank
0
MOS technology (format 81)
0
30 seconds
0 seconds
255
No
Single device
1
Disabled
Disabled
command (or
NTER
5-5