Data I/O UniSite-xpi User Manual page 182

4. Commands
4-48
5. When the programmer is ready to write the Custom Menu (CM)
algorithm list to a disk, the following message is displayed:
Insert Custom Menu algorithm disk. Hit Return to
continue.
Insert the disk that you want the Custom Menu files to be written to
and press E .
NTER
If you get the message
you need to delete some files on your target disk to make more room
for the CM files, or insert a different disk that has enough space for
the files.
6. After the programmer is done copying files, the programmer
displays a list of devices (if algorithm type K was selected in step 2)
or a list of device manufacturers (if algorithm type D or E was
selected in step 2).
Examine the list and select a device or device manufacturer by typing
the number corresponding to the selection and pressing E
device or device manufacturer you want is not listed, press C
to see the next page of devices or manufacturers.
7. If you selected a manufacturer in step 6, a list of devices produced by
the selected manufacturer appears. Type the number corresponding
to the device you wish to add to your Custom Menu, and press
to add the device. If the device or device manufacturer you
E
NTER
want is not listed, C
8. If prompted, insert the Algorithm disk that contains the algorithm
you wish to add. (If you do not have the correct disk inserted, the
programmer will prompt you for the disk to insert when it is
necessary.)
If you get the message
programmer could not find a file on the disk inserted into the
programmer's drive. Insert the Algorithm disk that contains the file.
9. Select additional devices from the current screen (or press F2 to
return to the manufacturer list if you were selecting devices from a
manufacturers list). Repeat steps 6 through 8 as necessary.
When you are done adding devices, press F2 twice until you are
prompted to insert the Custom Menu disk.
10. Insert the Custom Menu disk and press E
to disk. To add additional devices to your Custom Menu, use the
Add command (described below).
File ERROR: Cannot allocate file space
+ N to see the next page of devices.
TRL
Cannot access file_name.sys
NTER
,
. If the
NTER
+ N
TRL
, the
to save your changes
UniSite-xpi User Manual