Overwriting User Ram; Factory Default Settings - Data I/O UniSite-xpi User Manual

Overwriting User RAM

Factory Default
Settings
UniSite-xpi User Manual
The following operations use User RAM as a temporary storage buffer,
overwriting any data that may have been there previously.
• Duplicate disk
• Copy file
• Serial output from disk file
• Download data to disk file
• Self-test User RAM
UniSite-xpi's system parameters are initialized to certain settings at the
factory. You can restore these factory defaults at any time by selecting
configuration file number 0 from the More Commands/Configure
System/Restore menu. From the Restore System Parameters menu, press
0, E to re-elect the factory settings. The power-up defaults
NTER
(configuration file number 1) are the same as the factory defaults when
the unit is shipped from Data I/O.
Parameter
Algorithm Type
Blank Check
Checksum Calculation
Continuity Check
Compare Electronic ID
Data source/destination
Data Word Width
Device Begin Address
Device Block Size
Display device footnote
Enable download echo
Enable security fuse
Enable special data
Enable terminal beep
Enable yield tally option
EE bulk erase option
EOF delimiter flag (download)
EOF delimiter flag (upload)
File delimiter character (download)
File delimiter character (upload)
Filename
Fill RAM before downloading
Fill RAM with data (00 to FF)
High speed download
• Upload data from disk file
• Output data to disk from disk file
• Input data from disk to disk file
• Compare data to disk file
• Create and Add Custom Menu
Algorithms
Factory Default Setting
D
Yes
8
Yes
Yes
RAM
8
0
1000
Yes
No
No
No
Yes
No
No
No
No
1A (C -Z)
TRL
1A (C -Z)
TRL
Blank
No
00
Yes
4. Commands
4-3