Keep Current - Data I/O UniSite-xpi User Manual

Approved Terminals

Keep Current

View
UniSite-xpi User Manual
UniSite-xpi is compatible with the terminal types listed below. If your
terminal is not included in the list, refer to the manual supplied with the
terminal to determine if it can emulate one of those listed below.
• ANSI 3.64 compatible terminals
• DEC VT-100 compatible terminals
• Qume QVT-101 compatible terminals
• TELEVIDEO TVI-910 compatible terminals
• Wyse WY-30 compatible terminals
The commands in the Keep Current menu allow you to access Keep
Current algorithm files (.KCx). Commands available on this menu
include the following:
• View
• Replace/Restore
• Delete
• Purge
Note: For information on how to select a device supported by a Keep Current
algorithm, refer to "Select Device" on page 4-5.
This command allows you to view a list of .KCx files.
Configure
More
System
Com-
mands
View displays information on all .KCx files found on drives A and B.
Compatibility between system software and Keep Current algorithms is
not checked.
To view Keep Current algorithm files, follow these steps:
1. Insert the disk with the .KCx files you want to view into either disk
drive.
2. When you select the View command, the dialog window fills with a
directory listing. UniSite-xpi displays up to 10 files at one time. If
there are more than 10 files, press C
of files. Press C + P to display the previous page of files.
TRL
If you want to view files on another disk, press F2, insert another
disk, and return to the beginning of this step.
4. Commands
Keep Cur-
View
rent
+ N to display the next page
TRL
4-43