Advertisement
Figure 1.3
Refer to
Figure 4
for the connection diagram for an external analog signal setpoint reference.
Note: When b1-01 = 1 (terminals) and P5-01 = 0 (hand mode reference source), the setpoint and the hand reference are
determined by the external analog signal.
Figure 1.4
If you want the iQpump drive to receive the "Auto Setpoint" from serial communication: Set b1-01 = "2: Serial Com," and connect
the RS-485/422 serial communications cable to terminals R+, R-, S+, and S- on the control I/O terminal block.
Refer to
Figure 5
for the connection diagram using a PC to provide the auto setpoint reference to the iQpump drive. Further information
regarding communication protocols are referenced in
YASKAWA TM.iQp.02 iQpump Drive Programming Manual
Figure 3 Setpoint Potentiometer Connection Diagram
Figure 4 External Analog Signal Setpoint Reference
Appendix
A.
11
Hide quick links:
Advertisement
