YASKAWA iQpump Series Programming Manual page 130

Figure 1.99
Sleep Level
P2-02
Min. Frequency
P1-06
STOP, 0Hz
System
Set-Point
Start Level Delay
Start Level
P1-04
0%
Auto Mode Run
OFF Mode
Sleep Active
Wait for Start
Start System
If P2-01 = "1: Output Current"
The iQpump drive can be configured to enter a "sleep" condition based on output current. The drive will enter the sleep mode when the
output current falls below the programmed Sleep Level (P2-02) for a time specified by the Sleep Delay Time (P2-03).
This function is only active during operation in the Auto Mode. The display will indicate "Sleep" alarm when active.
The Sleep Level Type works in conjunction with the Sleep Level (P2-02), Sleep Delay Time (P2-03), and Alternative Sleep Activate
Level (P2-20). A multi-function digital output can be programmed to enable sleep (H1-xx = 82).
130
Output Frequency
P1-05
AUTO MODE RUN
START DELAY
Figure 104 Sleep Function Based on Output Frequency
Sleep Delay Time
P2-03
SLEEP ACTIVE
Start System, Incoming Run Command
TIME
Start Level Delay
P1-05
AUTO MODE STOP
AUTO MODE RUN
START DELAY
YASKAWA TM.iQp.02 iQpump Drive Programming Manual
Feedback