Quasonix TIMTER Installation And Operation Manual page 45

Multi-mode dual telemetry transmitter
Hide thumbs Also See for TIMTER:
Table of Contents

Advertisement

Mnemonic
Name
Command
CD
Channel Delay
CDE
Channel Delay
Enable
CF
Clock Free
Disable
38
Quasonix, Inc.
Description
Report or set the channel delay
for the currently active channel(s)
Valid range is 0 to 5000 in
nanoseconds.
Currently ONLY useful with STC
mode where the desire is to
adjust the delay on a channel to
compensate for antenna length
differences. To Enable or Disable
the delay, use the CDE
command.
Examples:
CD
Report the current
channel delay value
CD 500.0
Set the channel
delay to 500 nanoseconds
Enables or disables the use of the
channel delay
Currently ONLY useful with STC
mode where the desire is to
adjust the delay on a channel to
compensate for antenna length
differences. Set the channel delay
value with the CD command.
Examples:
CDE
Show the current CDE
state
CDE 0 Disable channel delay
CDE 1 Enable channel delay
Report or set the clock free state
In clock free mode, the transmitter
uses the narrowest data pulses to
determine the clock rate of the
data, and no input clock is
needed (any input clock is
ignored)
Examples:
CF
Report the clock free
state
CF 0
Unit uses its internal bit
sync (internally synthesized)
CF 1
Unit uses its externally
applied clock
TIMTER™ Multi-mode Dual
Telemetry Transmitter
Option (s)
Setting
Required
Saved?
STC mode
Y
STC mode
Y
CF
Y
Factory
Default
CDE 0
CF 0

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TIMTER and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents