Installing The Software In The Processor - 724 - Sony HDS-7100 User Manual

Software Installation
Installing the Software in the Processor – 724
Installing the operation software in the processor
10-32
Chapter 10 Setup Operations
Notes
• If there are snapshots or effects data stored in the processor
registers, this data will be destroyed by installing the software.
Before beginning the installation operation, save the contents of
registers to floppy disk.
For details of saving to floppy disk, see the section "Saving
register contents – SAVE" (page 8-15).
• If using option boards, complete the installation of the option
boards before installing the software. If you add option boards
after installing the software, it is necessary to install the software
again.
To install the operation software for the processor, use the
following procedure.
1
Insert the floppy disk labeled "SYSTEM DISK 1" in the drive.
2
With the third set of soft key indications shown in the SETUP
& DIAG menu, press F4 (INSTALL) to display the INSTALL
menu.
INSTALL MANUAL
INSTALL
INSTALL menu soft key indications
3
Press F1 (INSTALL).
4
To confirm the installation, press F5 (OK); to abort the
installation, press F6 (CANCEL).
The installation begins. The process takes approximately 10
minutes, during which no other operations are possible.
If the installation completes normally, a message "Finished"
appears.
RETRY OK CANCEL ON/OFF