Moving The Image; Moving In The Source Coordinate Frame - Sony HDS-7100 User Manual

Moving the Image

Moving in the Source Coordinate Frame

Procedure
Moving along the x-axis
SRCE button
LOC XYZ button
(or LOC SIZE button)
This section describes how to move the image in either the source
or target coordinate frame.
To move the image in the source coordinate frame, use the
following procedure in the transformation operation section.
1
In the function allocation section, press the SRCE button,
turning it on.
2
In the transformation mode selection section, press the LOC
XYZ button, turning it on.
If you wish to move the image in the x- and y-directions only,
pressing the LOC SIZE button has the same effect.
3
Move the trackball to move the image in the x- and y-
directions.
Turn the Z-ring to move the image in the z-direction.
RUN
CURSR
CTRL
SRCE TRGT
ASP
LOC LOC
SKEW
SIZE XYZ
PERS
AXIS
ORTHG ROT
LOC
X Y Z
VELO
CTR
HOLD
SEL/FINE
Control panel operation
Chapter 3 Three-Dimensional Transformations
Video change
3-9