Sony HDS-7100 User Manual page 77

Setting parameter values
• Using the mouse:
Use the following procedure.
1
Align the cursor with the indication for the channel you wish
to make the reference channel, and press and hold down the
left mouse button.
The selected channel indication turns green, and this becomes
the reference channel.
2
With the left mouse button held down, drag the cursor to the
indication for the other channel you wish to make active, then
release the left mouse button.
The second selected channel indication turns red, indicating
that it is also active.
There are five different ways to set the value of a parameter
displayed on the screen.
These are described below, taking as an example the "Lum"
parameter for SOURCE FLAT in the screen shown on page 4-11.
The descriptions of operations in Chapter 5 and subsequent
chapters refer only to making settings with the soft knobs.
Using the soft knobs
Use the following procedure.
1
Use the J and j buttons, to display the SOURCE FLAT line
in green.
2
Turn the left knob to adjust the luminance value.
Using the numeric keypad
Use the following procedure.
1
Use the J and j buttons, to display the SOURCE FLAT line
in green.
2
Press the KNOB LEFT button in the numeric keypad section.
3
Enter the value for the luminance using the numeric keypad.
You can alternatively enter a trim value, that is, the difference
from the current value.
Chapter 4 Menu Operations
4-13