Settings Related To Operation - 702 - Sony HDS-7100 User Manual

Settings Related to Operation – 702
Selecting the initializing mode for the working keyframe buffer –
F1 (CLEAR WRK BUFF)
Selecting the power on mode – F2 (POWER ON)
This menu controls various settings related to operation from the
control panel.
With the first set of soft key indications shown in the SETUP &
DIAG menu, press F2 (OPERATION) to display the
OPERATION menu.
702 OPERATION
•
Clear Work Buff Factory set
•
Power On Factory set
•
Top Menu Button Top menu
•
Disable
Editor Interface
•
GPI Interface Disable
•
Switcher Interface Disable
CLEAR POWER TOP MENU
WRK BUFF ON BUTTON
The following are some of the operations carried out in this menu.
Pressing the CLR WORK BUFF button in the keyframe operation
section initializes the working keyframe buffer. There are two
options for the state to which the working keyframe buffer is
cleared, selected by pressing F1 (CLEAR WRK BUFF) as follows.
Factory set: Clear to the factory default settings.
User define: Clear to the settings determined using F8 (CLR
WRK DEFINE).
There are three options for the initial state of the display when the
system is powered on, selected by pressing F2 (POWER ON) as
follows.
Factory set: Initialize to the factory default settings.
User define: Initialize to the settings determined using F7 (PWR
ON DEFINE).
•
User define
•
User define
•
Last menu
• •
DME protocol VTR protocol
•
Enable
•
Enable
EDITOR GPI SW'ER
IF IF IF
OPERATION menu
Chapter 10 Setup Operations
E G 1 2 R
PWR ON CLR WRK
DEFINE DEFINE
10-7