Yamaha TW200 Service Manual page 35

_ _ _ _ _ _ M_A_IN_T_E_N_A_N_C_E_S_P_EC_I_FI_C_A_TI_O_N_S_I
SPEC
I
~
71
TIGHTENING TORQUE
Parts to be tightened Thread size
Tightening torque
Remarks
Nm
m.kg
ft·lb
Engine stay (Front) and engine/frame M8 x 1.25
33
3.3
24
Engine stay (Top) and engine/frame M8 x 1.25
33 3.3 24
Engine and frame M8 x 1.25 33 3.3
24
Helmet holder and-frame M6 x 1.0
4
0.4
2.9
Engine protector and engine/frame M6 x 1.0
7
0.7
5.1
License bracket and frame M6 x 1.0 5
0.5 3.6
Air cleaner case and frame M6 x 1.0 5 0.5 3.6
Pivot shaft and nut M12x1.25 80 8.0 58
Rear shock absorber and frame M12x1.25 50 5.0
36
Drive chain case and rear arm M5 xO.8 4 0.4 2.9
Drive chain guard and rear arm M6 x 1.0 5 0.5 3.6
Drive chain support and rear arm M6 x 1.0 5 0.5 3.6
Handle crown and inner tube M8 x 1.25 23 2.3
17
Under bracket and inner tube
23 2.3 17
Handle crown and steering shaft M14x1.25
90
9.0 65
Steering shaft and ri,ng nut
M25x1.0 6 0.6 4.4
Refer to NOTE
Headlight stay and handle crown
M6 x 1.0 7 0.7 5.1
Fuel tank and frame M6 x 1.0 7 0.7 5.1
Front wheel axle and nut M14x1.5 90 9.0 65
Brake cam lever and shaft M6 x 1.0 9 0.9 6.5
Brake drum mounting bolt M8 x 1.25 28 2.8 20
Rear wheel axle and nut M16x1.5 90 9.0 65
Rear wheel sprocket and wheel hub M8 x 1.25 35 3.5 25
Footrest (Right) and frame M10x1.25 45 4.5 32
Footrest (Left) and frame M12x1.25 60 6.0 43
Rear footrest and frame M8 x 1.25 14 1.4 10
Sidestand and frame M10x 1.25
40
4.0 29
Horn and frame M6 x 1.0 7 0.7 5.1
Main switch and handle crown M6 x 1.0 7 0.7 5.1
Rectifier with regulator and frame M6 x 1.0 7 0.7 5.1
NOTE: _
• Ring nut (lower):
1) First, tighten the ring nut approximately 38 Nm (3.8 m.kg, 27 ft·lb) by using the torque
wrench, then loosen the ring nut completely.
2) Retighten the ring nut 6 Nm (0.6 m.kg, 4.4 ft·lb).
2-13