Yamaha TW200 Service Manual page 147

Screws (Crankcase Cover):
7 Nm (0.7 m-kg, 5.1 ft-Ib)
Bolt (Change Pedal):
10 Nm (1.0 m-kg, 7.2 ft-Ib)
Bolt (Footrest):
60 Nm (6.0 m-kg, 43 ft-Ib)
NOTE: _
Install the change pedal so that its top height
®
is same as footrest.
!1.1I111 _
-Before installing the crankcase cover (Left),
route the neutral lead
(j)
and starter motor
lead
®
under the drive axle.
- Pass the COl magneto leads
@
in front of
the drive axle as shown.
-Take care not to pinch the above leads with
crankcase cover (Left).
Refer to IICHAPTER 3-CABLE ROUTING"
section.
ENGINE ASSEMBLY AND ADJUSTMENT
1
ENG
I ' ..
I
4. Install:
-Dowel pins
-Gasket (New)
- Crankcase cover (Left)
@
-Change pedal
CD
- Footrest (Left)
®
-Clamp
@
@
Clamp
5. Install:
Exhaust pipe
Exhaust Pipe Mounting Bolts:
10 Nm (1.0 m-kg, 7.2 ft-Ib)
Bolt (Exhaust Pipe-Muffler):
27 Nm (2.7 m-kg, 19 ft-Ib)
6. Adjust:
- Drive chain slack
®
Refer to IICHAPTER
3-
DRIVE CHAIN AD-
JUSTMENT" section.
Drive Chain Slack:
30-40
mm
(1.2-1.6
in)
4-67