Il
300-001
1-4
SPECIAL TOOLS
II~~~ I ~I
CIRCLIPS
1. All circlips should be inspected carefully be-
fore reassembly. Always replace piston pin
clips after one use. Replace distorted circlips.
When installing a circlip
CD,
make sure that
the sharp edged corner
@
is positioned op-
posite to the thrust
@
it receives. See the
sectional view.
@
Shaft
SPECIAL TOOLS
The proper special tools are necessary for com-
plete and accurate tune-up and assembly. Using
the correct special tool will help prevent damage
caused by the use of improper tools or improvised
techniques.
FOR TUNE-UP
1. Inductive Timing Light
PIN. YU-33277
This tool is necessary for adjusting the ignition
timing.
2. Fuel Level Gauge
PIN. YM-01312
This gauge is used to measure the fuel level in
the float chamber.
3. Inductive Tachometer
PIN. YU-08036
This tool is needed for detecting engine r.p.m.