Yamaha TW200 Service Manual page 59

I
IANOSJP
I
~
I
ENGINE OIL REPLACEMENT
~.
---------------------------
6. Install:
-Oil strainer
- Compression spring
-O-ring
-Drain plug
-Bolt (Oil filter cover- Lower)
Drain Plug:
43 Nm (4.3 m-kg, 31 ft-Ib)
Bolt (Oil Filter Cover- Lower):
10 Nm (1.0 m-kg, 7.2 ft-Ib)
7. Fill:
-Crankcase
With recommended engine oil.
Recommended Engine Oil:
Refer to page 3-12.
Oil Capacity (Without Oil Filter
Change):
1.0 L (0.88 Imp qt, 1.06 US qt)
·.·:::.:;::.;::::.!e:(;II.IJ.:: . • . . : · · . · . : ; . : · . . · · . .
· .·.:.:N.:.::.:· .•.;.··.' ..
: : . : . · ~ . ·
• .: • .•. ; •. !.:•. :.·.•. : 1.:.;.·•. ·.:
;:;:::;:;:;:;:;:;:::::::;:::::::::::::::::::
-----------
- Do not add any chemical additives. Engine
oil also lubricates the clutch and additives
could cause clutch slippage.
- Be sure no foreign material enters the
crankcase.
8. Inspect:
- Engine oil level
Refer to the I/ENGINE OIL LEVEL INSPEC-
TION" section.
9. Install:
- Oil filler cap
10. Warm up the engine and check for oil leaks.
Stop the engine instantly if leaking occurs.
- Leaks--+ Check cause.
With Oil Filter Change
Follow the IIWithout Oil Filter Change" steps
1-5.
Then proceed as follows:
1. Remove:
-Oil filter cover
CD
-Oil filter
3-13