Yamaha TW200 Service Manual page 181

STEERING AND HANDLEBAR
ICHASI
~
I
3. Tighten:
-Ring nut
Ring nut tightening steps:
-Tighten the ring nut using the Ring Nut
Wrench
CD.
~
Ring Nut Wrench:
~
- PIN YU-33975
NOTE: _
Set the torque wrench to the ring nut wrench
so that they form a right angle.
Ring Nut (Initial Tightening):
38 Nm (3.8 m.kg, 27 ft·lb)
-Loosen the ring nut one turn.
- Retighten the ring nut using the Ring Nut
Wrench.
WARNING:
Avoid over-tightening.
Ring Nut (Final Tightening):
6 Nm (0.6 m •. kg, 4.4 ft·lb)
4. Install:
- Handle crown
@
- Steering stem bolt
CD
NOTE: _
Temporary tighten the steering fitting bolt.
5. Install:
-Front fork
Refer to the "FRONT FORK-INSTAL-
LATION" section.
®
6 mm (0.24 in)
Pinch Bolt (Under Bracket):
23
Nm (2.3 m.kg, 17 ft·lb)
Pinch Bolt (Handle Crown):
23 Nm (2.3 m.kg, 17 ft·lb)
6-23