Install I-8092F Software Into Xpac_Xpe - ICP DAS USA I-8092F Getting Started Manual

3.2.3 Install i-8092F software into XPAC_XPe

The necessary files for
XPAC_XPe
, execute the setup.exe to start installation automatically. These files then will
be copied into the specific directories.
When the installation is completed, the driver and library will be copied into the system
directory defined in Windows XPe. And the relevant utilities are installed into
C:\ICPDAS\I8092F_XPAC_XPe.
［Notice］
The XPAC_XPe protects its hard drive with EWF (Enhanced Write Filter),Before driver installing
or system registry changing, please disable EWF. And enable the EWF after driver installing or
registry changing.
Please refer to chapter 2.4 in xpac_8000_user_manual for detailed EWF settings.
The utilities are:
MotionCfg – To configured the i8094/F and i8092F in XPAC_XPe. When XPAC_XPe
boots up, the OS will refer to those configuration and activate the relative i-8092F
modules.
i8092F EzGo – Provide the similar features of PISO-PS200 EzGo utility. This utility
helps to indicate the status of each axis, configure the polarity of external sensors
and demonstrate the basic/simple motion-controlling models.
i8092F EzFRnet – Demonstrate the FRnet features.
http://www.icpdas.com
XPAC_XPe
now are packed into the installation package. In
31
I8092F Getting Started ManualVer.2.3