A2.3 Jumper And Switch Settings - ICP DAS USA I-8092F Getting Started Manual

RJ1 (The I/O signals of the FRnet)
The connectors RJ1 is an 8-pin RJ45 connector that enable you to connect to the signals
of FRnet. Fig.B2-8 shows the pin assignment for the 8-pin connector on the DN-8237-MB,
and the Table B2-8 shows its I/O connector signal description.

A2.3 Jumper and Switch Settings

JP5
Jumper 5 controls the EMG-A signal of the TB1 connector. The following diagram is
shown the selection condition of the jumper 5.
http:/www.icpdas.com
Fig. B2-9 Jumper 5 setting
63 I8094Getting Started Manual for WinPAC Ver.1.1