ICP DAS USA I-8092F Getting Started Manual page 30

Pac motion control module

Hide thumbs Also See for I-8092F:

Table of Contents

If the software package is installed, one dialog will appear to make sure the 're-install'

when CAB updating; and if the driver is used by some activated i-8094/F modules,

WinPAC will show the following message.

Please cancel the CAB installation, remove i-8092F configurations with MotionCfg utility

and excute 'Save and Reboot' in WinPAC_Utility. Afetr WinPAC re-starting, the CAB

updating will be successful.

http://www.icpdas.com

I8092F Getting Started ManualVer.2.3

Table of Contents